Container with plastic cover

Made of high quality, deep pressed steel sheet, appropriate design to ensure safety and resistance to mechanical impacts.

further information

Volume: 1.1m3 (1,100 liters)
Container is produced according to standards: SRPS EN 840-3:2008, SRPS EN 840-5:2008 and SRPS EN 840-6:2010
Container is dimensionally in accordance with standard 30700
Container fully corresponds to purpose, according standards: 840-6
Container dimensions: 1360x1050x1430 mm
Sheet steel 1.2 ÷ 1.5 mm thick
Side supports for emptying the container
Two handrails on the front, one handrail on each lateral side, and one on the cover
Plain, made of plastics
Metal mechanism for foot opening – closing of the cover (step lever) at the front
Lateral side
Made of one peace, welded to container shell
Container body
Bottom, front and back side are made completely of one peace, shell of the container
Bottom of the container
Rounded in radius R400 extracted by plastic deformation together with front and back side of the container
Reinforcement on the bottom
4 supports set along the hole length, from front to back wheels, where the highest force of bottom deformation is placed during manipulation
Supporting the container on four (4) wheels with metal rim and rubber coating hardness 80 SCHOR
Four wheels, all swivel and bolted to the body of the container
Diameter of the wheel ∅ 200 mm
Load capacity 200 kg by the wheel
Rotation angle 360⁰
All metal parts are galvanized
Two front wheels with brake mechanism (foot brake)
Two rear wheels free (without braking mechanism)
Water drain
Water drain on the bottom of the container
Wheel carrier
Wheel carrier is made of sheet steel ≠4 mm
Anticorrosive protection is performed by hot-dip galvanizing in accordance with EN standard ISO 1461
Surface protection: Hot dip galvanizing
Warranty period:
2 years